To Load A Configuration - Agilent Technologies HP 1660E Series User Manual

File Management
Transferring Files Using the Flexible Disk Drive

To load a configuration

You can quickly load a previously saved configuration, so that you will
not have to manually set up the measurement parameters.
1 Go to the System Hard Disk or System Flexible Disk menu.
Your choice here depends on where you saved the configuration.
2 Select the field below System and select Load from the pop-up
menu.
3 Select the destination from the module list.
"System" loads only settings available under the System menus.
"Analyzer" loads data and settings for the analyzer. "All" loads both the
system and analyzer configurations.
You can only load configuration files to the area from which the
configuration was taken. For instance, you cannot load an analyzer
configuration file to the system. Thus, if you select System, then select
a file that contains only an analyzer configuration, the configuration
will fail. The file type field tells you what type of information is in a file.
Analyzer configuration files show "166xan_config" for the 1660's and
"167xan_config" for the 1670's, and system configurations show
"16[6/7]x_cnfg" in the file type field.
4 Specify a file name from which to load the configuration using
the from file field or scrolling with the knob.
242