1 Turn off both instruments, and connect the cable.
2 Turn on the logic analyzer and then the controller.
3 In the System External I/O menu, select the field under
4 Select the appropriate Settings field and configure the values in
See Also
Connecting Peripherals
Connecting Peripherals
To connect to a controller
You can control the HP 1660E/ES/EP-series logic analyzer with another
instrument, such as a computer running a program with embedded
analyzer commands. The steps below outline the general procedure for
connecting to a controller using HP-IB or RS-232-C.
If you are using RS-232-C, the cable must be a null-modem cable. If you
do not have a null-modem cable, you can purchase an adapter at any
electronics supply store.
Connected To: in the Controller box and set it appropriately.
the pop-up menu to be compatible with the controller.
HP 1660E/ES/EP or HP 1670E-Series Logic Analyzers Programmer's
Guide and the LAN section of this book starting on page 494 for more
information on connecting controllers.
48