To Check The Power-Up Tests - Agilent Technologies HP 1660E Series User Manual

Logic analyzers

Table of Contents

Operator's Service

Troubleshooting

To check the power-up tests

The logic analyzer automatically performs power-up tests when you

apply power to the instrument. The revision number of the operating

system shows in the upper-right corner of the screen during these

power-up tests. As each test completes, either "passed" or "failed"

prints on the screen in front of the name of each test.

1 Disconnect all inputs, then insert a formatted disk into the

flexible disk drive.

2 Let the analyzer warm up for a few minutes, then cycle power by

turning off then turning on the power switch.

If the analyzer is not warmed up, the power-up test screen will

complete before you can view the screen.

3 As the tests complete, check if they pass or fail.

The Flexible Disk Test reports No Disk if a disk is not in the disk drive.

Performing Power-Up Self-Tests

Interrupt test

Display test

PS2 Controller Test

Hard Disk Test

Flexible Disk Test