To Make A Measurement - Agilent Technologies HP 1660E Series User Manual

Logic Analyzer Overview
HP 1660/70-Series Logic Analyzer

To make a measurement

For more detail on any of the information below, see the referenced
chapters or the Logic Analyzer Training Kit. If you are using an analysis
probe with the logic analyzer, some of these steps may not apply.
Map to target
Connect probes
Connect probes from the target system to the logic analyzer to
physically map the target system to the channels in the logic analyzer.
Attach probes to a pod in a way that keeps logically-related channels
together. Remember to ground the pod.
"Probing" on page 258 for more detail on constructing probes.
See Also
Set type*
When the logic analyzer is turned on, Analyzer 1 is named Machine 1
and is configured as a timing analyzer, and Analyzer 2 is off. To use
state analysis or software profiling, you must set the type of the
analyzer in the Analyzer Configuration menu. You can only use one
timing analyzer at a time.
33