Agilent Technologies HP 1660E Series User Manual page 273

NOTE 1:
NOTE 2:
HP 10466A 3-State TTL/3.3 Volt Data Pod
Output type
3-state enable
Maximum clock
Skew
Recommended lead set HP 10474A
Typical skew measurements made at pod connector with
approximately 10 pF/50K ohm load to GND; worst case skew numbers
are a calculation of worst case conditions through circuits.
Channel 7 on the 3-state pods has been brought out in parallel as a non
3-state signal. By looping this output back into the 3-state enable line,
the channel can be used as a 3-state enable.
74LVT244 with 100 ohm in series
10H125 on non 3-state channel 7 (see note 2)
negative true, 100K ohm to GND,
enabled on no connect
200 MHz
Typical <3 ns; worst case 7 ns (see note 1)
Logic Analyzer Reference
Probing
273