Agilent Technologies HP 1660E Series User Manual page 520

Logic analyzers

Table of Contents

Using the LAN's X Window Interface

Pseudo telnet method using a UNIX computer

To enable windows to be initiated from the logic analyzer named

lp1660E, enter the following command on the computer running the

xhost +lp1660E

To connect to the command parser socket of the logic analyzer named

lp1660E, enter:

telnet lp1660E 5025

HP logic analyzers are not telnet servers. The UNIX command telnet is used to

make a connection to the analyzer command parser, which uses socket

number 5025. A telnet server would normally not need to have the socket

To start the XWindow interface on the computer whose IP address is

15.6.253.146 (and is running the Xserver) enter:

xwin on,"15.6.253.146:0.0"

If you are not planning on sending more commands to the logic

analyzer, close the telnet connection by typing the escape character,

and then "quit" when the telnet prompt appears. The escape character

is often Control-]; your telnet program should tell you when it opens

the connection.

Troubleshooting