Logic Analyzer Reference
The RS-232-C, HP-IB, and Centronics Interfaces
The RS-232-C, HP-IB, and Centronics Interfaces
This section describes the controller and printer interfaces and their
configurations found in the System External I/O menu. It defines the
HP-IB interface and describes how to select a different HP-IB address.
It also defines the RS-232-C interface and tells you how to select a baud
rate, how to change the stop bits, how to set the parity and data bits,
and how to change the flow control protocol. The Centronics (parallel)
interface (for printers only) and LAN interface (controller only) are
also described.
Controller interface
The logic analyzer is equipped with standard RS-232-C, HP-IB, and
Ethernet LAN interfaces that allow you to connect to a controller. All of
the interfaces give you remote access for running measurements and
uploading and downloading configurations and data.
Printer interface
The logic analyzer can output its screen to various HP-IB, RS-232-C,
and Centronics graphics printers. Configured menus, as well as
waveforms and other data, can be printed for complete measurement
documentation. The analyzer cannot use a networked or shared
printer.
See Also
"Connecting Peripherals" on page 40 for more details on physically
connecting equipment.
HP 1660E/ES/EP or HP 1670E-Series Logic Analyzers Programmer's
Guide for more information on the controller interface.
The LAN section of this book on page 494 more information on the
LAN interface.
292