To Enter Commands Directly Using Telnet - Agilent Technologies HP 1660E Series User Manual

Logic analyzers

Table of Contents

Programming the Logic Analyzer Using the LAN

To enter commands directly using telnet

The syntax of the telnet command is:

telnet [symbolic name|IP address] 5025

The symbolic name is the host name of the logic analyzer as set up by

your system administrator. Typically, this name is found in the hosts file

or returned by a name server. It is equivalent to the logic analyzer's IP

5025 is the port identification number of the logic analyzer's command

parser socket. It must be specified because the logic analyzer is not a

fully functional telnet server. If you forget to specify the port, you will

get a connection refused message:

$ telnet 1660sys

telnet: Unable to connect to remote host: Connection

To enter commands directly using telnet, first open a telnet connection

using port 5025. A brief message appears confirming the connection,

and telling you how to break the telnet connection:

$ telnet 1660sys 5025

Connected to 1660sys.col.hp.com

Escape character is '^]'.

When you connect to the logic analyzer, there is no prompt. Type logic

analyzer commands; query results appear on the next line. When you

are done, break the telnet connection using the escape character, and

type "quit".

See the detailed example on the next page.