Self Cal Menu Calibrations - Agilent Technologies HP 1660E Series User Manual

Logic analyzers

Table of Contents

Self Cal menu calibrations

Messages will be displayed as each calibration routine is completed to

indicate calibration has passed or failed. The resulting calibration

factors are automatically stored to nonvolatile RAM at the conclusion

of each calibration routine.

The Self Cal menu lets you optimize vertical sensitivity (Vert Cal) for

channels 1 and 2 individually or both channels on a board

simultaneously. Also, the Self Cal menu lets you optimize delay (Delay)

for channel 1 and 2 separately, then Time Null for channel 2 and the

Logic Trigger.

1 Optimize Vert Cal of the Self Cal.

a Connect two BNC 50-W, 9-inch cables to the BNC tee adapter.

Connect the BNC 50W (f)(f) adapter to the BNC tee adapter,

and connect the 48-inch BNC cable to the BNC 50W (f)(f)

adapter. Once you select Start, the instrument will prompt

you to connect the cables to the appropriate locations on the

rear panel of the instrument.

b Select the Mode field, then select Self Cal from the pop-up

c Select the Procedure field, then select Vert Cal from the pop-

d Select the Channel field, then select a channel choice from the

pop-up menu.

e Select the Start field and follow the instructions on the

f After completion of Vertical Calibration, remove the cables

from the instrument.

Using the Oscilloscope

Calibrating the oscilloscope