1-6. Initial Programming
1. Date and Time - Function 50
1.
Make sure that the machine is in standby mode.
2.
Press Function, enter 50, then press Yes.
3.
Type the date at the keypad.
4.
Change the month.
Example: Change JAN to MAY.
Press # four times. Press * to come back if you go too far.
If the month is correct, press Clear to move the cursor.
5.
Type in the date and time at the keypad. If the display is correct, press Function.
2. Telephone Line Type - Function 81
This must match the dialling method accepted by the exchange, or the machine will not be able to dial.
1. Make sure that the unit is in standby mode.
Note: German, Italian, and Universal versions - Enter the service mode. Press 1, 2, 3, *, 0, and #
2. Press Function, enter 81, then press Yes. The top line of the display shows the present setting.
3. To select tone dialling, press 1. To select pulse dialling, press 2.
4. Press Function if the setting is correct.
Note: If using pulse dial and the local exchange cannot handle 20 pps dialling, set bit 7 of bit switch 10
to 1 (see page 2-17 for how to program bit switches).
simultaneously.
1-19