Getting Started
Installing the NPD Control Card
The NPD control card must be installed into the proper expansion slot marked A,
B or C located on the left part of the GC mother board in the electronic
compartment. Refer to Figures 1-5 and 1-6.
NOTE
In the case all the expansion slots are occupied, it is necessary to remove one of the three
detector control card currently installed and replace it with the NPD control card.
Material needed:
•
1. Loosen the fixing screw of the slot cover plate that corresponds to the selected
Installation Guide
3-mm Allen wrench
A, B or C expansion slot on the mother board.
1. Slot cover plate
3. Free slot
C
1
B
3
A
2. Cover plates fixing screw
A B C. Extension slot position
Figure 1-5. Extension Slots Top View
Upgrade Kit
Nitrogen Phosphorus Detector
2
13