Upgrade Kit
NPD Tandem Detector
Installing the NPD Control Card
The NPD control card must be installed into the proper expansion slot marked C
located on the left part of the GC mother board in the electronic compartment.
Refer to Figures 1-14 and 1-15.
NOTE
In the case all the expansion slots are occupied, it is necessary to remove the "C" detector
control card currently installed and replace it with the NPD control card.
Do not remove the ECD control card already installed.
Material needed:
•
1. Loosen the fixing screw of the slot cover plate that corresponds to the selected
18
3-mm Allen wrench
1. Slot cover plate
3. Free slot
C expansion slot on the mother board.
C
1
B
3
A
2. Cover plates fixing screw
A B C. Extension slot position
Figure 1-14. Extension Slots Top View
Getting Started
2
Installation Guide