Position The Projector; Install The Lamp Power Supply In A Rack Stand - Christie D4K3560 Setup Manual

Position the projector

1. Position the projector at an appropriate throw distance (projector-to-screen distance) and
vertical position. Ideally, center the projector with the screen. If space is limited, aim the
projector slightly off-center. This increases side keystoning, but reduces the horizontal lens
offset required.
Keep the projector lens as perpendicular to the screen as possible, even if significantly above
the screen center. When a particularly short throw distance combines with a wide screen, you
may have to forfeit some aim and stay more perpendicular to the screen. In such cases, some
lens offset can reduce the keystone distortion.
2. Position the lamp power supply (LPS) so its cables reach the lens side of the projector.
3. If using an optional rack stand (P/N: 108-282101-02), assemble the rack stand using the
instructions provided with the rack stand. Use the hold down clamp (P/N: 116-100101-01)
when securing the projector to the rack stand.

Install the lamp power supply in a rack stand

1. Remove the right (operator's side) panel of the rack stand.
2. Remove the cross bar.
3. Insert the lamp power supply (LPS) support into the rack stand and align the pins with the
holes.
4. Lift the LPS into the frame.
5. Remove the bottom 10 panels from the back of the rack stand.
D4K3560 Setup Guide
020-101161-05 Rev. 1 (06-2015)
90°
Installation and Setup
≠90°
15