Install The New Lamp - Christie Solaria One Service Manual

Section 3: Parts and Module Replacement
9. For the CDXL-21S1 lamp:
a. Loosen the cathode screw (4) on the cathode clamp (6).
b. Hold the anode end of the lamp with your left hand and then carefully unscrew and remove the cathode
nut with your right hand (5).
c. As you hold the anode end of the lamp, carefully guide the lamp through the reflector ensuring not to
make contact with the reflector.
d. With your right hand guide the cathode end out of the reflector, on an angle through the lamp access
door.
10. Open a protective lamp case and then place the old lamp into the case. Thread the cathode nut onto the
lamp, close the protective case, and then place the lamp within the case, on the floor where it cannot fall or
be bumped. WARNING! Handle the protective case with extreme caution - the lamp is
hazardous even when packaged. Dispose of lamp box according to local area safety
regulations.
11. Install the new lamp. See

3.14.2 Install the New Lamp

NOT over-tighten. DO NOT stress the glass in any way. Check leads. Ensure the anode (+)
lead between the lamp and igniter is well away from any projector metal, such as the reflector
or fire wall.
1. Remove the existing lamp. See
2. Open the box containing the new lamp and then remove the tape from the ends of the protective case.
3-12
3
2
1
1
2
3
4
5
6
Install the New Lamp on page
Handle the lamp by the cathode/anode end shafts only, never the glass. DO
Remove the Existing Lamp on page
Anode Terminal
Anode Wire
Reflector
Cathode Screw
Cathode Nut
Cathode Clamp
3-12.
4
5
6
3-10.
Solaria One/Solaria One
020-101039-02 Rev. 1 (06-2013)
+
Service Manual