Install First Lamp - Christie Roadie HD+35K Setup Manual

Anamorphic Lens Installation (Optional)
NOTE: The optional anamorphic lens mount is required for use of the 1.26x anamorphic lens, producing
2.39:1 "scope" images. However, the lens mount cover must be removed when installing the anamorphic lens
mount and in order to the use the MALM.
If the anamorphic lens is used, it is recommended that you add the lens and its mount before final leveling or
making any adjustments (i.e. boresight, etc.). Install only for those installations requiring full-size 2.39:1
"scope" display (mostly side-masking screens) obtained by optically stretching a pre-squeezed image.
1. Install the anamorphic lens mount on the projector.
At the front of the projector, install the anamorphic lens mount hardware as described in the instructions
provided with the Christie Anamorphic Lens Mount Kit.
2. Install the 1:26x anamorphic lens.
Clamp the 1.26x anamorphic lens mount in place, following the instructions provided with the anamorphic
lens mount kit.

2.4.2 Install First Lamp

1. Open the lamp door and remove lamp cooling compartment door.
2. Install one of the following lamps in the projection head, depending on your model and site:
• 2.0 kW*
• 3.0 kW*
• 4.5kW*
• 6.0 kW*
NOTE: 3-phase ballast is required.
* Available as CDXL (maximum performance) or original CXL.
Roadie HD+35K Setup Guide
020-100394-06 Rev. 1 (10-2013)
Explosion Hazard. Wear authorized protective clothing whenever the lamp
door is open.
Figure 2-10 Open Lamp Door and Cooling Compartment
Section 2: Installation and Setup
2-15