Install The Lamp Power Supply In A Rack Stand - Christie Mirage 4K35 User Manual

Install the lamp power supply in a rack stand

1. Remove the right (operator's side) panel of the rack stand.
2. Remove the cross bar.
3. Insert the lamp power supply (LPS) support into the rack stand and align the pins with the
holes.
4. Lift the LPS into the frame.
5. Remove the bottom 10 panels from the back of the rack stand.
6. Assemble the three-piece airflow duct (supplied with LPS). First snap the two L shaped parts
together, and then snap this into the six stand out pins of the third piece (flat panel).
7. Position the airflow duct directly behind the LPS.
Do not install any components in front of the lamp power supply that will restrict airflow.
i
8. Insert airflow duct into rack stand from the outside.
9. Secure airflow duct to rack stand using screws from the rack stand panels.
Mirage 4K35 User Manual
020-101377-03 Rev. 1 (07-2015)
6
5
3
Installation and Setup
4
25