Install The New Lamp; Add The Lamp To The Lamp History - Christie CP2215 Service Manual

Parts and Module Replacement

Install the New Lamp

Handle the lamp by the cathode/anode end shafts only, never the glass. Do not over-
tighten. Do not stress the glass in any way. Check leads. Ensure the anode (+) lead between
the lamp and igniter is well away from any projector metal, such as the reflector or fire wall.
Failure to comply could result in minor or moderate injury.
1. Remove the existing lamp. See
2. Open the box containing the new lamp and then remove the tape from the ends of the protective
case.
3. Remove the plastic packing material from the lamp.
4. Remove the cathode nut from the lamp before removing it from the case.
5. Hold the anode end of the new lamp in your left hand and angle it up through the hole in the back
of the reflector assembly. Insert your right index and middle finger through the back of the
reflector and guide the lamp onto the cathode clamp. Be careful not to hit the lamp against the
reflector
6. Thread on and hand-tighten the cathode nut. Ensure the smooth portion of the nut is against the
cathode clamp.
7. Tighten the cathode screw (D) with a hex key.
8. Align the ring terminal on the anode wire (B) with the mounting position ensuring the crimped
side of the wire is facing out. Tighten the anode screw.
Make sure you route the anode lead away from nearby metal surfaces.
9. Close the lamp access door and tighten the 2 thumbscrews.
10. Place the hex key into its holder and then close and lock the rear access door.
11. Add the lamp to the lamp history. See

Add the Lamp to the Lamp History

1. Connect the projector to AC power and then turn the projector on.
2. Tap Menu > Advanced Setup > Lamp Change Wizard.
3. Tap Next.
4. Complete these fields:
Field
Type
Serial Number
Reason for Change
Lamp Expiry (Hours)
Hours Used
30
Remove the Existing Lamp
Add the Lamp to the Lamp History
Lamp type.
Lamp serial number.
Reason the lamp was changed.
Number of hours the lamp can operate before replacement.
Number of hours the lamp has operated before installation.
on page 28.
Description
020-101226-03 Rev. 1 (10-2015)
on page 30.
CP2215 Service Manual