Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 69

Analog Synths
Attack
0-100. This sets the attack time of the filter envelope, which controls how long it
takes from the moment that the key is pressed until the envelope reaches its peak.
Decay
0-100. This sets the decay time of the filter envelope, which controls how long it
takes the envelope to fall to the sustain level after the attack is complete.
Sustain
0-100. This sets the sustain level for the filter envelope. After the decay time is
complete, the envelope will stay at this level as long as the note is held.
Release
0-100. This sets the release time of the filter envelope, which controls how long it
takes the envelope to fall to zero after the note is released.
NOTE: The Release button (see page 56) must be enabled for the release portion of
the envelope to sound. If the Release button is turned off, the envelope will fall to
zero immediately upon note off.
ADSR Envelope
Amp ADSR
These parameters control an ADSR envelope dedicated to the output volume. For a
graphic explaining ADSR envelopes, see the figure "ADSR Envelope," above.
The Amp Env switch determines whether the amplifier will use this ADSR
envelope, or the simple Amp AR envelope. Switching to the AR envelope allows
you to use the ADSR envelope as a poly mod source, and adjust it as desired
without affecting the output volume.
OASYS PCI
Attack time Decay time
Sustain
Level
Release time (with
Sustain while Release button on)
holding note
Pro Synth Mod
61