St Harmonicchr - Korg Soundlink DRS OASYS PCI Patches & Effects Manual

St HarmonicChr

St HarmonicChr
This is a stereo-in, stereo-out harmonic chorus, which applies chorus only to higher
frequencies. It can be used to apply a chorus effect to a bass sound without making
the sound thinner. You can also add feedback, to turn the chorus into a flanger.
Shifting the left and right LFO phases from each other will enhance the stereo
width.
Input
Level
-INF, -69.0 to 0.0dB. This sets the input level for the effect. It does not affect the dry
signal.
Hi/Low Xover
0-100. This sets frequency for the crossover filter. Only the audio above the
crossover point is sent through the chorus; audio below the crossover point is sent
directly to the outputs.
Stereo Harmonic Chorus
Left Delay
0.0-50.0ms. This sets the delay time for the left channel, in milliseconds.
Right Delay
0.0-50.0ms. This sets the delay time for the right channel, in milliseconds.
Depth
0-100. This controls the depth of LFO pitch modulation.
Depth Mod
List of Modulation Sources. This sets the modulation source for controlling the
LFO depth. For a complete list, please see "Modulation Sources" on page 2.
Mod Amount
+/-100. This sets the amount by which the mod source affects the LFO depth.
Feedback
+/-100. This sets the feedback amount of the chorus. Increasing the feedback will
change the chorus into a flanger.
Damping
0-100. This controls the high-frequency damping in the feedback path.
268
Chorus
OASYS PCI