Room Ambience - Korg Soundlink DRS OASYS PCI Patches & Effects Manual

Reverbs

Room Ambience

This effect provides the reverberant wash of the "Room Reverb" effect, without the
early reflections or pre-delay, and with only low shelving EQ. It uses relatively little
DSP processing power.
Input
Source
Left, L + R. This is a mono-in, stereo-out effect. Stereo signals are preserved in the
dry mix at the output, but the effect itself has only a single, mono input.
When this is set to Left, only the left channel will be routed into the effect.
When this is set to L + R, the left and right channels will be summed together, and
then routed into the effect.
Level
-INF, -69.0 to 0.0dB. This sets the input level for the effect. It does not affect the dry
signal.
Pre EQ
Low Freq
0-10000Hz. This sets the cutoff frequency of the pre-effect low shelving EQ, in Hz.
This is the point at which gain is 3dB below maximum, as shown in the figure
"High and Low Shelving EQ," on page 382.
Low Gain
+/-18.1dB. This sets the amount of gain for the pre-effect low shelving EQ.
Ambience
Reverb Time
0.10-3.00sec. This is the time it takes for the reverb to decay.
Damping
0-100. This is the amount of high-frequency damping in the reverb. If Damping is
set to 0, the high frequencies will decay at the same rate as the low frequencies; at
100, the high frequencies will decay almost instantly. In real acoustic spaces, high
frequencies generally delay somewhat faster than low frequencies, so moderate
amounts of damping will create a more realistic sound.
OASYS PCI
Room Ambience
625