Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 63

Analog Synths
Decay
0-100. This sets the decay time of the amplitude envelope, which controls how long
it takes the envelope to fall to the sustain level after the attack is complete.
Sustain
0-100. This sets the sustain level for the amplitude envelope. After the decay time is
complete, the envelope will stay at this level as long as the note is held.
Release
0-100. This sets the release time of the amplitude envelope, which controls how
long it takes the envelope to fall to zero after the note is released.
NOTE: The Release button (see page 56) must be enabled for the release portion of
the envelope to sound. If the Release button is turned off, the envelope will fall to
zero immediately upon note off.
Master Tune
Master Tune
+/- 100. This adjusts the master tuning of the synth, in cents (1/100 of a semitone).
Osc Edge
Key Track
0-100. This adjusts the way that the brightness of the oscillator tracks the keyboard.
Controller Mod
Source Mix
0-100. Both the LFO and the noise generator can be used as modulation sources.
This knob determines the balance between the two. At 0, only the output of the LFO
is used; at 100, only the noise generator is used.
The Mod Controller and Initial parameters control the amount of modulation.
Freq A
On, Off. This selects the frequency of oscillator A as a modulation destination.
Freq B
On, Off. This selects the frequency of oscillator B as a modulation destination.
PW A
On, Off. This selects the pulse width of oscillator A as a modulation destination.
PW B
On, Off. This selects the pulse width of oscillator B as a modulation destination.
OASYS PCI
Pro Synth
55