4-Tap Chorus - Korg Soundlink DRS OASYS PCI Patches & Effects Manual

4-Tap Chorus

4-Tap Chorus
This effect has four chorus blocks, each with a different LFO phase. You can create a
complex stereo image by setting each block's delay time, depth, output level, and
pan individually. You can also set some of the chorus blocks to combine the chorus
and delay effects.
Input
Source
Left, L + R. This is a mono-in, stereo-out effect. Stereo signals are preserved in the
dry mix at the output, but the chorus effect itself has only a single, mono input.
When this is set to Left, only the left channel will be routed into the effect.
When this is set to L + R, the left and right channels will be summed together, and
then routed into the effect.
Level
-INF, -69.0 to 0.0dB. This sets the input level for the effect. It does not affect the dry
signal.
Taps 1-4
Delay
0.0-440.0ms. This sets the delay time for the tap, in milliseconds.
Depth
0-100. This controls the depth of LFO pitch modulation for the tap.
Level
0-100. This sets the output volume level for the tap.
Pan
0-100. This sets the stereo output position for the tap.
Tap 1 Feedback
Feedback
+/-100. This sets the delay feedback for tap 1.
Feedback Mod
List of Modulation Sources. This sets the modulation source for controlling tap 1's
delay feedback. For a complete list, please see "Modulation Sources" on page 2.
246
Chorus
OASYS PCI