Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 573

Phasers
Note EG Retrig
On, Off. This determines the way that the envelope triggers when the Trigger
Source is set to Note Gate or Note Gate + Sustain.
On. When this is on, the envelope will be triggered whenever a key is pressed.
Off. When this is off, the envelope will only be retriggered after all currently held
notes have been released.
EG Attack
0-100. This sets the attack time of the envelope–the time that it takes to reach its
maximum value after being triggered.
EG Decay
0-100. This sets the release time of the envelope–the time that it takes to fall back to
its minimum value after the trigger is released.
Resonance
+/-100. This sets the amount of resonance in the phaser effect. Higher resonance
settings create a more extreme sound.
Damping
0-100. This controls the amount of high frequency damping in the phaser
resonance.
Spread
+/-100. This controls the width of the effect's stereo image, without affecting the dry
signal. A value of +100 gives the widest stereo image, and a value of 0 collapses the
output to mono. Negative values will reverse the left and right channels of the
effect output.
Output
Wet/Dry
Dry, 1:99-99:1, Wet. This sets the balance between the effect and the dry signal.
Wet/Dry Mod
List of Modulation Sources. This sets the modulation source for controlling the
wet/dry mix. For a complete list, please see "Modulation Sources" on page 2.
Mod Amount
+/-100. This sets the amount by which the mod source affects the wet/dry mix.
Invert Wet Phase
On, Off. This allows you to invert the phase of the wet signal.
OASYS PCI
St Env Phaser
565