Ring Modulator - Korg Soundlink DRS OASYS PCI Patches & Effects Manual

Ring Modulator

Ring Modulator
This effect creates a metallic sound by routing the input signal to an oscillator. You
can create very extreme effects by modulating the oscillator using an LFO or MIDI
modulation. Since the oscillator frequency can match the note number, you can
create a ring modulation effect that follows the scale.
Input
Source
Left, L + R. This is a mono-in, stereo-out effect. Stereo signals are preserved in the
dry mix at the output, but the effect itself has only a single, mono input.
When this is set to Left, only the left channel will be routed into the effect.
When this is set to L + R, the left and right channels will be summed together, and
then routed into the effect.
Level
-INF, -69.0 to 0.0dB. This sets the input level for the effect. It does not affect the dry
signal.
Ring Mod
Pre LPF
0-100. This adjusts the cutoff of the pre-effect lowpass filter.
Osc Mode
Fixed, Note. This sets the way that the oscillator will be controlled.
Fixed. The oscillator will use the frequency set under the Fixed section.
Note. The oscillator will follow incoming MIDI notes.
Fixed
Fixed Freq
0-12000Hz. This sets the basic pitch of the oscillator when the Osc Mode is set to
Fixed.
Fixed Freq Mod
List of Modulation Sources. This sets the modulation source for controlling the
Fixed frequency. For a complete list, please see "Modulation Sources" on page 2.
Mod Amount
+/-12000. This sets the amount by which the mod source affects the oscillator
frequency.
488
Modulations
OASYS PCI