Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 356

St Midi Dly
Note Value
1/32, 1/32 dotted, 1/16, 1/16 dotted, 1/16 triplet, 1/8, 1/8 dotted, 1/8 triplet, 1/4, 1/4
dotted, 1/4 triplet, 1/2, 1/2 dotted, 1/2 triplet, 1 bar, 2 bars. This sets the length of
the tap's delay, in note value.
This parameter only applies when the Delay Mode is set to Tempo. When Delay
Mode is set to Delay Time, the Note Value has no effect.
Fine Adjust
+/-10%. This adjusts the tap's delay time as a percentage of the time set with either
the Delay Time or Note Value parameters. You can use this to create swing
rhythms, for instance.
Level
0-100. This sets the volume level of the tap.
Invert Phase
On, Off. This adjusts the phase of the tap's output. You can use this to create
different tonal qualities as the delays overlap with each other, or with the main
signal.
Pan
+/-100. This controls the stereo pan of the tap's output.
Feedback
0-100. This adjusts the amount of feedback from the tap back into the delay line.
Invert Phase
On, Off. This controls the phase of the feedback. You can use this to adjust the tonal
quality of the delay, as it overlaps with other delays or with the main signal.
Low Cut
24-24000Hz. This filter cuts the tap's low frequencies. Use this to make the delay
sound thinner.
High Cut
24-24000Hz. This filter cuts the tap's high frequencies. Use this to make the delay
sound warmer, like a tape delay.
Stereo Link
On, Off. This allows you to link the controls of the two channels.
On. The controls for the Left Delay will control the Right Delay as well.
Off. The Left and Right Delays will be controlled separately.
348
Delay
OASYS PCI