Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 67

Analog Synths
Oscillator B
Frequency
+/- 48. This sets the coarse tuning of the oscillator over an eight-octave range, in
half-steps.
Fine
+/- 100. This sets the fine tuning of the oscillator, in cents (1/100 of a semitone).
Shape
Sawtooth, Pulse, Triangle. This selects the waveform of oscillator B. If Pulse is
selected, the Pulse Width control, below, sets the width of the pulse.
Pulse Width
0-100. This sets the width of the pulse waveform, as a percentage of the full
waveform cycle. 50.0 produces a square wave, smaller amounts produce a
waveform with a shorter "up" time, and greater amounts produce a waveform
with a longer "up" time, as shown below. For a diagram, see the figure "Pulse
Width," above. Pulse width can also be modulated via the LFO.
Lo Freq
On, Off. This shifts the oscillator to a low-frequency pitch range. The Lo Freq mode
is most useful when oscillator B is being used as a Poly Mod source.
Keyboard
1-100. This adjusts oscillator B's pitch tracking, centered on B3. Note that you can
also modulate any parameter using the "Key Tracking" modulators in the Mod
Palette.
Mixer
Osc A
0-100. This controls the output level of oscillator A.
Osc B
0-100. This controls the output level of oscillator B.
Noise
0-100. This controls the output level of the noise generator.
OASYS PCI
Pro Synth Mod
59