Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 617

Reverbs
Pan
0-100. This sets the stereo pan of the early reflection.
Reverb
Reverb Time
0.10-10.00. This is the time it takes for the reverb to decay.
Damping
0-100. This is the amount of high-frequency damping in the reverb. If Damping is
set to 0, the high frequencies will decay at the same rate as the low frequencies; at
100, the high frequencies will decay almost instantly. In real acoustic spaces, high
frequencies generally delay somewhat faster than low frequencies, so moderate
amounts of damping will create a more realistic sound.
Pre Delay
0.0-200.0ms. This is the amount of delay time before the reverberant wash begins,
in milliseconds. The ER delays are not affected by the Pre Delay.
Pre Delay Thru
0-100. This allows you to route the un-delayed input directly to the reverb, in
addition to the Pre Delay.
Output
Rolloff
0-24000Hz. This controls an overall lowpass filter on the output of the reverb.
Settings around 6-8kHz are good for producing a warm, smooth sound.
ER Level
0-100. This sets the volume level for the four early reflections (ER 1-4).
Reverb Level
0-100. This sets the volume level for the reverberant wash.
Wet/Dry
Dry, 1:99-99:1, Wet. This sets the balance between the effect and the dry signal.
Wet/Dry Mod
List of Modulation Sources. This sets the modulation source for controlling the
wet/dry mix. For a complete list, please see "Modulation Sources" on page 2.
Mod Amount
+/-100. This sets the amount by which the mod source affects the wet/dry mix.
OASYS PCI
Hall Reverb
609