Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 620

O-Verb
Q
0.25-32.00. This sets the bandwidth of the parametric mid band. Low Q means a
wider bandwidth, for more gentle, broad EQ; high Q means a narrow bandwidth,
for cutting or boosting very specific frequencies. A Q of 0.25 is creates a bandwidth
of slightly more than four octaves; a Q of 32 creates a bandwidth of about 1/22 of
an octave, or about half a semitone.
The Q is identical for boost and cut, which may be referred to as "symmetric Q."
Some specific EQs use asymmetric Q, in which a given Q for cut is 1/3 the actual
bandwidth of the same Q for boost. So, if you are used to a particular type of
equalizer, and the Q in this effect doesn't seem right when cutting, try multiplying
the Q by three.
Output
Rolloff
0-24000Hz. This controls an overall lowpass filter on the output of the effect.
Settings around 6-8kHz are good for producing a warm, smooth sound.
Wet/Dry
Dry, 1:99-99:1, Wet. This sets the balance between the effect and the dry signal.
Wet/Dry Mod
List of Modulation Sources. This sets the modulation source for controlling the
wet/dry mix. For a complete list, please see "Modulation Sources" on page 2.
Mod Amount
+/-100. This sets the amount by which the mod source affects the wet/dry mix.
612
Reverbs
OASYS PCI