Hyper-Gain - Korg Soundlink DRS OASYS PCI Patches & Effects Manual

Hyper-Gain

Hyper-Gain
This distortion effect includes enhanced-quality "hyper gain" mode and four-band
parametric EQ.
Input
Source
Left, L + R. This is a mono-in, mono-out effect. Stereo signals are preserved in the
dry mix at the output, but the effect itself has only a single, mono input.
When this is set to Left, only the left channel will be routed into the effect.
When this is set to L + R, the left and right channels will be summed together, and
then routed into the effect.
Level
-INF, -69.0 to 0.0dB. This sets the input level for the effect. It does not affect the dry
signal.
Overdrive/Hyper-Gain
Pre Low-cut
0-100. This cuts low frequencies before the input to the distortion.
Mode
Overdrive, Hi-Gain. Switches between overdrive and hi-gain distortion.
Drive
0-100. Sets the amount of distortion.
Out Level
0-100. Sets the output level.
Out Level Mod
List of Modulation Sources. This sets the modulation source for controlling the
output level. For a complete list, please see "Modulation Sources" on page 2.
Mod Amount
+/-100. This sets the amount by which the mod source affects the output level.
Direct Mix
0-100. This allows you to route the dry sound through the final DC-cut filter,
bypassing the rest of the distortion effect.
360
Distortion
OASYS PCI