Decimator - Korg Soundlink DRS OASYS PCI Patches & Effects Manual

Decimator

Decimator
The Decimator downsamples incoming audio to create a gritty, rough effect. You
can modulate the sample rate via MIDI controllers.
Input
Source
Left, L + R. This is a mono-in, mono-out effect. Stereo signals are preserved in the
dry mix at the output, but the effect itself has only a single, mono input.
When this is set to Left, only the left channel will be routed into the effect.
When this is set to L + R, the left and right channels will be summed together, and
then routed into the effect.
Level
-INF, -69.0 to 0.0dB. This sets the input level for the effect. It does not affect the dry
signal.
Decimator
Pre LPF
On, Off. This turns the pre-effect lowpass filter on and off. The lowpass can be used
to smooth out some of the more extreme effects of the sample rate conversion!
Sample Rate
1000-24000Hz. This converts the sample rate of the audio, downsampling to create
a gritty-sounding effect.
Sample Rate Mod
List of Modulation Sources. This sets the modulation source for controlling the
sample rate. For a complete list, please see "Modulation Sources" on page 2.
Mod Amount
+/-24000Hz. This sets the amount by which the mod source affects the sample rate.
Damping
0-100. This sets the amount of high frequency damping.
Output
Wet/Dry
Dry, 1:99-99:1, Wet. This sets the balance between the effect and the dry signal.
510
Other Effects
OASYS PCI