Flanger - Korg Soundlink DRS OASYS PCI Patches & Effects Manual

Flanger

Flanger
This is a mono-input, mono-output flanger.
Input
Source
Left, L + R. This is a mono-in, mono-out effect. Stereo signals are preserved in the
dry mix at the output, but the effect itself has only a single, mono input.
When this is set to Left, only the left channel will be routed into the effect.
When this is set to L + R, the left and right channels will be summed together, and
then routed into the effect.
Level
-INF, -69.0 to 0.0dB. This sets the input level for the effect. It does not affect the dry
signal.
Flanger
Delay
0.0-50.0ms. This sets the center delay for the flanger.
Depth
0-100. This controls the depth of LFO modulation.
Feedback
+/-100. This controls the amount of feedback in the flanger. Higher feedback
settings result in a more extreme sound.
Hi Damping
0-100. This adjusts the amount of high frequency damping in the feedback loop.
LFO
Waveform
Triangle, Sine. This selects the waveform for the LFO.
Shape
+/-100. This adjusts the shape of the LFO waveform. Positive values shape the
curve so that it spends more time in the "up" part of the cycle, and negative values
make it spend more time in the "down" part of the cycle, as shown below.
454
Flangers
OASYS PCI