2Band Pitchshift - Korg Soundlink DRS OASYS PCI Patches & Effects Manual

2Band PitchShift

2Band PitchShift
This effect uses a crossover on the input, and then sends the resulting two bands
through two independent pitch shifters.
Input
Source
Left, L + R. This is a mono-in, stereo-out effect. Stereo signals are preserved in the
dry mix at the output, but the effect itself has only a single, mono input.
When this is set to Left, only the left channel will be routed into the effect.
When this is set to L + R, the left and right channels will be summed together, and
then routed into the effect.
Level
-INF, -69.0 to 0.0dB. This sets the input level for the effect. It does not affect the dry
signal.
Two Band Pitch Shifter Control
Type
Fast, Medium, Slow. This sets the response time and quality of the pitch shifters.
The slower the response, the higher the quality.
Lo/Hi Split
24-20000Hz. This sets the crossover frequency between the high and low pitch
shifters.
Lo/Hi Bal
0-100. This sets the level balance between the high and low pitch shifters.
Spread
+/-100. This controls the width of the effect's stereo image, without affecting the dry
signal. A value of +100 gives the widest stereo image, and a value of 0 collapses the
output to mono. Negative values will reverse the left and right channels of the
effect output.
Low
Pitch Shift
+/-24. This sets the amount of pitch shift for the low band, in semitones.
594
Pitch Shifters
OASYS PCI