Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 187

PCM
To make sure that the LFO's phase is correct when working with a sequencer, it's
best to include the phase reset controller every few bars in the sequence, so that no
matter where you start playback, the LFO will be reset appropriately.
Frequency
The controls in the Frequency section only apply when the LFO Control is set to
Frequency Knob.
Frequency
0.00-20.00Hz. This controls the speed of the LFO when the LFO Control is set to
Frequency Knob.
Frequency Mod
List of Modulation Sources. This sets the modulation source for controlling the
LFO speed. For a complete list, please see "Modulation Sources" on page 2.
Amount
+/-20.00Hz. This sets the amount by which the mod source affects the LFO speed.
Fade-In
0-100. The LFO can be at full level instantly, or can fade in over time after a note is
played. This parameter controls how long it takes the LFO to rise to full level after
the first note is pressed.
When you release all notes on the keyboard, and then play a new note, the LFO
fade-in will start again.
Tempo
Manual Tempo
40-240 bpm. This sets the tempo when the LFO Control is set to Manual Tempo.
Subdivision
1/32, 1/32 dotted, 1/16, 1/16 dotted, 1/16 triplet, 1/8, 1/8 dotted, 1/8 triplet, 1/4, 1/4
dotted, 1/4 triplet, 1/2, 1/2 dotted, 1/2 triplet, 1 whole note, 2 whole notes. This
sets the note value of a single LFO waveform cycle when the LFO Control is set to
either Manual Tempo or MIDI Tempo.
Global LFO 2
The parameters for Global LFO 2 are the same as those for Global LFO 1, as
described above.
OASYS PCI
Xenon 4+
179