Auto Wah - Korg Soundlink DRS OASYS PCI Patches & Effects Manual

Auto Wah

Auto Wah
This is a model of a wah pedal, which can be swept either by an envelope follower
or by a MIDI controller.
Input
Source
Left, L + R. This is a mono-in, stereo-out effect. Stereo signals are preserved in the
dry mix at the output, but the effect itself has only a single, mono input.
When this is set to Left, only the left channel will be routed into the effect.
When this is set to L + R, the left and right channels will be summed together, and
then routed into the effect.
Level
-INF, -69.0 to 0.0dB. This sets the input level for the effect. It does not affect the dry
signal.
Wah/Auto Wah
Cutoff Bottom
0-100. This sets the frequency of the wah when the modulation is at its minimum
value.
Cutoff Top
0-100. This sets the frequency of the wah when the modulation is at its maximum
value
Sweep Mode
Auto, Mod Source. This determines how the wah will be controlled.
Auto. The wah will be controlled by the envelope follower.
Mod Source. The wah will be controlled directly from the MIDI mod source.
Mod Source
List of Modulation Sources. This sets the modulation source for controlling the
wah sweep, when Sweep Mode is set to Mod Source. For a complete list of sources,
please see "Modulation Sources" on page 2.
Mod Response
0-100. This sets the rate at which the wah frequency changes in response to the
modulator.
408
Filters
OASYS PCI