St Phaser - Korg Soundlink DRS OASYS PCI Patches & Effects Manual

St Phaser

St Phaser
This is a stereo-in, stereo-out phaser effect.
Input
Level
-INF, -69.0 to 0.0dB. This sets the input level for the effect. It does not affect the dry
signal.
Stereo Phaser
Center
0-100. This sets the center frequency of the phaser.
Depth
0-100. This controls the amount of LFO modulation of the center frequency.
Hi Damping
0-100. This controls the amount of high frequency damping in the phaser
resonance.
Resonance
+/-100. This sets the amount of resonance in the phaser effect. Higher resonance
settings create a more extreme sound.
Spread
+/-100. This controls the width of the effect's stereo image, without affecting the dry
signal. A value of +100 gives the widest stereo image, and a value of 0 collapses the
output to mono. Negative values will reverse the left and right channels of the
effect output.
LFO
Waveform
Triangle, Sine. This selects the waveform for the LFO.
Shape
+/-100. This adjusts the shape of the LFO waveform, from logarithmic to linear to
exponential. Positive values shape the waveform so that it spends more time in the
"up" part of the cycle, and negative values make it spend more time in the "down"
part of the cycle, as shown below.
566
Phasers
OASYS PCI