Low Cut Filter - Korg Soundlink DRS OASYS PCI Patches & Effects Manual

EQ

Low Cut Filter

This is a mono-in, mono-out low cut filter, with a choice of 12dB or 24dB per octave
slope. As with all EQs in the OASYS PCI, the curves are smooth and symmetrical in
frequency, modeling analog EQs.
For the more technically inclined, the EQ calculations are all double-precision,
using first-order error-feedback.
Input
Source
Left, L + R. This is a mono-in, mono-out effect. Stereo signals are preserved in the
dry mix at the output, but the effect itself has only a single, mono input.
When this is set to Left, only the left channel will be routed into the effect.
When this is set to L + R, the left and right channels will be summed together, and
then routed into the effect.
Level
-INF, -69.0 to 0.0dB. This sets the input level for the effect. It does not affect the dry
signal.
Note that extreme positive or negative gain settings can dramatically increase the
volume within the EQ effect, so it may be necessary to decrease the input volume to
avoid clipping.
High Cut Filter
Frequency
24-24000Hz. This sets the cutoff frequency for the low cut filter.
Slope
12dB/Octave, 24dB/Octave. This selects the severity of the low cut filter.
OASYS PCI
Low Cut Filter
395