Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 229

Waveguide
Mode/Tune
0.0-100.0. This models the distance from the mouth to the mouthpiece, which
affects the pitch. Flautists will vary this distance to make small pitch corrections, by
rolling the flute towards the mouth or away from it.
Small values will produce detuning; this range represents the practical distance
that can be achieved by a real flautist. The model allows you to go further than you
could in the real world, however, and after a certain point the pitch will jump by an
octave into the next pitch mode. (Real-world flautists can create this mode jump by
blowing very hard.)
Damping
0-100. This controls the brightness of the bore.
Key Track
0-100. This allows you to vary the damping according to the MIDI note.
Pitch Controllers
You can bend the pitch of the flute smoothly, or make it leap up and down by an
octave in a "Mode Jump," which real flautists can create by blowing very hard.
Pitch Bend
List of Modulation Sources. This sets the modulation source for creating a smooth
pitch bend. For a complete list, please see "Modulation Sources" on page 2.
Mode Jump
List of Modulation Sources. This sets the modulation source for controlling the
mode jump. For a complete list, please see "Modulation Sources" on page 2.
LFO
The LFO allows you to modulate both pitch and breath pressure.
Frequency
0.0-10.0 Hz. This controls the initial speed of the LFO.
Frequency Mod
List of Modulation Sources. This sets the modulation source for controlling the
LFO frequency. For a complete list, please see "Modulation Sources" on page 2.
Amount
0.0-10.0Hz. This sets the amount, in Hz, by which the mod source affects the LFO
frequency. When the mod source is at its maximum value, it will add this amount to
the setting on the Frequency knob.
OASYS PCI
Flute
221