O-Verb Xl - Korg Soundlink DRS OASYS PCI Patches & Effects Manual

Reverbs

O-Verb XL

This is the most comprehensive version of the O-Verb reverb, adding two MIDI-
synced delays and eight ER delays to the reverb core.
Input
Source
Left, L + R. This is a mono-in, stereo-out effect. Stereo signals are preserved in the
dry mix at the output, but the effect itself has only a single, mono input.
When this is set to Left, only the left channel will be routed into the effect.
When this is set to L + R, the left and right channels will be summed together, and
then routed into the effect.
Level
-INF, -69.0 to 0.0dB. This sets the input level for the effect. It does not affect the dry
signal.
Diffusion 1
0.00-100.00. The two diffusers serve to soften the sound before it enters the reverb
core. The four early reflections delays may also use the output of one or both of the
diffusers.
Diffusion 1 sets the amount of diffusion in the first diffuser. Setting both diffusers to
around 50 produces sufficient diffusion for smooth reverbs; extremely high levels
may cause ringing. Certain material, such as vocals, may also benefit from lower
settings of diffusion, allowing for more discrete echoes.
Diffusion 2
0.00-100.00. This sets the amount of diffusion in the second diffuser.
Reverb
Size
0-100. This sets the size of the reverberant space.
Reverb Time
0.00-100.00. This sets the decay time for the reverberant wash. The Damping, Bass
XOver, and Bass Gain parameters allow you to scale the decay times for the high
and low frequencies.
Damping
24-24000Hz. This sets the cutoff of the high-frequency damping filter. If Damping is
set to 24000Hz, the high frequencies will decay at the same rate as the low
OASYS PCI
O-Verb XL
619