Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 329

Delay
Invert Phase
On, Off. This controls the phase of the feedback. You can use this to adjust the tonal
quality of the delay, as it overlaps with other delays or with the main signal.
Low Cut
24-24000Hz. This filter cuts the tap's low frequencies. Use this to make the delay
sound thinner.
High Cut
24-24000Hz. This filter cuts the tap's high frequencies. Use this to make the delay
sound warmer, like a tape delay.
Feedback
Feedback Mod
List of Modulation Sources. This sets the modulation source for controlling the
delay feedback levels, affecting both delays equally. For a complete list, please see
"Modulation Sources" on page 2.
Mod Amount
+/-100. This sets the amount by which the mod source affects the feedback level.
Diffusion in feedback
On, Off. This controls whether the feedback will go through the diffusers or not.
On. The feedback signal will pass through the diffusers. As the feedback continues,
it will become increasingly diffuse.
Off. The feedback signal will not go through the diffusers, and so it will remain at
the same level of diffusion as the main delays.
Output
Direct Diffusion
0-100. This allows you to add in the sound of the diffusers alone, before the delays.
Rolloff
0-24000Hz. This controls an overall lowpass filter on the output of the delays.
Settings around 6-8kHz are good for producing a warm, smooth sound.
Wet/Dry
Dry, 1:99-99:1, Wet. This sets the balance between the effect and the dry signal.
Wet/Dry Mod
List of Modulation Sources. This sets the modulation source for controlling the
wet/dry mix. For a complete list, please see "Modulation Sources" on page 2.
OASYS PCI
Diffuse Delay
321