Harmonic Chorus - Korg Soundlink DRS OASYS PCI Patches & Effects Manual

Chorus

Harmonic Chorus

This effect applies chorus only to higher frequencies. This can be used to apply a
chorus effect to a bass sound without making the sound thinner. You can also add
feedback, to turn the chorus into a flanger.
Input
Source
Left, L + R. This is a mono-in, mono-out effect. Stereo signals are preserved in the
dry mix at the output, but the chorus effect itself has only a single, mono input.
When this is set to Left, only the left channel will be routed into the effect.
When this is set to L + R, the left and right channels will be summed together, and
then routed into the effect.
Level
-INF, -69.0 to 0.0dB. This sets the input level for the effect. It does not affect the dry
signal.
Hi/Low Xover
0-100. This sets frequency for the crossover filter. Only the audio above the
crossover point is sent through the chorus; audio below the crossover point is sent
directly to the outputs.
Chorus
Delay
0.0-50.0ms. This sets the delay time for the chorus, in milliseconds.
Depth
0-100. This controls the depth of LFO pitch modulation.
Depth Mod
List of Modulation Sources. This sets the modulation source for controlling the
LFO depth. For a complete list, please see "Modulation Sources" on page 2.
Mod Amount
+/-100. This sets the amount by which the mod source affects the LFO depth.
Sets the feedback amount of the chorus block. Increasing the feedback will allow
you to use the effect as a flanger.
OASYS PCI
Harmonic Chorus
255