Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 461

Flangers
EG Trigger/Mod
List of Modulation Sources. When Sweep Mode is set to EG, this selects the
modulation source that triggers the envelope. When Sweep Mode is set to Mod
Source, this selects the modulation source that controls the flanger. For a complete
list of modulation sources, please see "Modulation Sources" on page 2.
Note EG Retrig
On, Off. This determines the way that the envelope triggers when the Trigger
Source is set to Note Gate or Note Gate + Sustain.
On. When this is on, the envelope will be triggered whenever a key is pressed.
Off. When this is off, the envelope will only be retriggered after all currently held
notes have been released.
EG Attack
0-100. This sets the attack time of the envelope–the time that it takes to reach its
maximum value after being triggered.
EG Decay
0-100. This sets the release time of the envelope–the time that it takes to fall back to
its minimum value after the trigger is released.
Output
Mode
Mono, Stereo. This controls whether the effect output is mono or simulated stereo.
When this is set to Mono, the output is in mono.
When this is set to Stereo, the output is simulated stereo, with the right effect
output inverted. Note that this simulated stereo effect is not mono-compatible.
Wet/Dry
Dry, 1:99-99:1, Wet. This sets the balance between the effect and the dry signal.
Wet/Dry Mod
List of Modulation Sources. This sets the modulation source for controlling the
wet/dry mix. For a complete list, please see "Modulation Sources" on page 2.
Mod Amount
+/-100. This sets the amount by which the mod source affects the wet/dry mix.
Invert Wet Phase
On, Off. This allows you to invert the phase of the wet signal.
OASYS PCI
Envelope Flanger
453