Tenor Sax - Korg Soundlink DRS OASYS PCI Patches & Effects Manual

Waveguide

Tenor Sax

This Patch is a physical model of a tenor saxophone, including breath pressure, the
tonal quality of the breath noise, playing style, and the characteristics of the reed,
bore, and bell.
Breath Pressure
Input
0.0-100.0. This controls the overall force of the breath pressure, modeling how hard
you are blowing into the sax.
Input Mod
List of Modulation Sources. This sets the modulation source for controlling the
breath input. You might try using the mod wheel, or breath controller. For a
complete list, please see "Modulation Sources" on page 2.
Amount
0.0-100.0 This sets the amount by which the mod source affects the breath input.
Pressure
0.0-100.0. This controls how much of the input goes to the reed, as opposed to the
bore. If Pressure is set to 0, then the Reed and Growl sections will have little or no
effect, as if you were blowing into an open tube. At higher pressures, the Reed and
Growl will have more effect.
Pressure Mod
List of Modulation Sources. This sets the modulation source for controlling the
breath pressure. For a complete list, please see "Modulation Sources" on page 2.
Amount
0.0-100.0. This sets the amount by which the mod source affects the breath pressure.
Attack
0.0-100.0. This models the reed's resistance to opening, or how hard it is to get the
reed to start moving.
Release
0.0-100.0. This models the reed's resistance to closing.
OASYS PCI
Tenor Sax
223