Trombone - Korg Soundlink DRS OASYS PCI Patches & Effects Manual

Waveguide

Trombone

This Patch is a physical model of a trombone, including breath pressure, the
character of the breath noise, the timbre of the bell, and authentic "rip" and vibrato
effects.
Breath Pressure
Pressure
0.0-100.0. This controls the overall force of the breath pressure, modeling how hard
you are blowing into the trombone.
Pressure Mod
List of Modulation Sources. This sets the modulation source for controlling the
breath input. You might try using the mod wheel, or breath controller. For a
complete list, please see "Modulation Sources" on page 2.
Amount
0.0-100.0 This sets the amount by which the mod source affects the breath pressure.
Envelope
Env Amount
0.0-100.0 This sets the amount by which the envelope affects the breath pressure.
Attack
0-100. This sets the attack time of the envelope, which controls how long it takes
from the moment that the key is pressed until the envelope reaches its peak.
Decay
0-100. This sets the decay time of the envelope, which controls how long it takes the
envelope to fall to the sustain level after the attack is complete.
Sustain
0-100. This sets the sustain level for the envelope. After the decay time is complete,
the envelope will stay at this level as long as the note is held.
Release
0-100. This sets the release time of the envelope, which controls how long it takes
the envelope to fall to zero after the note is released.
Breath Noise
This section controls the timbre and level of the breath noise; think of it as the
sound that the player makes with their mouth, before entering the mouthpiece of
OASYS PCI
Trombone
227