Advertisement
P.52
7.2.1 LOCAL Start/Stop
a) START
Press the START button on the controller.
The Main Pump (MP) will start and the M.P. RUN lamp on the controller will
light.
After this, the Booster Pump (BP) will start automatically and the B.P. RUN
lamp on the controller will light.
The power is indicated on the display during pump operation.
For other status display indications, refer to Table 6.1.
[ NOTE ]
generated. When the START button is pressed, "STARTFAIL" will
appear on the display.
b) STOP
Press the STOP button on the controller. The MP and BP will stop
simultaneously.
The RUN lamp goes out and the display gives a power reading of 0.0kW.
7.2.2 REMOTE Start/Stop
a) START
Enter the external "MP" start signal input from the control connector.
The MP starts.
In the automatic BP operating mode, the BP can be started/stopped
automatically.
When the BP is operated under external start signal input, apply the external
BP start signal to the control connector.
The power is indicated on the display during pump operation. For other
status display indications, refer to Table 6.1.
[ NOTE ]
generated. When a START signal is entered, "STARTFAIL" will
appear on the display.
b) STOP
Interrupt the external MP start signal and the pump will stop.
PM10U
The pump will not start when an WARNING/ALARM has been
The pump will not start when a WARNING/ALARM has been
EBARA
CORPORATION
Advertisement
Troubleshooting
