Installation; Movement And Fixation; Location; Caster And Adjustment Foot - EBARA ESA200W Instruction Manual

Multi-stage dry vacuum pump

P.12

4. Installation

Be sure to take the following cautions and instructions into account when

installing the pump.

This pump is designed for indoor installation. To install the pump, select a place

with little exposure to dust and humidity and not subject to dew condensation.

Also allow for sufficient space to ensure easy pump installation and disassembly

for maintenance.

In case of installing interface box to the pump, the distance between pump

and interface box shall be 3m or less.

CAUTION

Four integral mobile support units consisting of a caster and a height-adjustment

foot each are provided underneath the pump base. To move the pump, raise the

four adjustment feet by turning the holding nuts in the counterclockwise direction.

PM10U

Install pump in a location at an ambient not exceeding 30°C.

Particular caution is required when the pump is operated in

an enclosed room.

A gap of at least 50mm should be left open for ventilation

between the pump cover and the adjacent equipment.

Caster

Fig. 4.1 Caster

Adjuster

(Vibroisolating rubber)

Approx 15mm

EBARA

CORPORATION

Table of Contents