Driveshaft Housing - TOHATSU 40 Service Manual

SECTION 5
Installation
Installation is done in the reverse order of Removal. Use
4
Loctite 242 on shift lever shaft holder bolts (1) if removed.

DRIVESHAFT HOUSING

Removal
1. Remove powerhead as described in Section 4.
2. Remove tiller steering handle if equipped, this section.
3. Remove lower engine cover, this section.
4. Remove gearcase as described in Section 6.
5. Remove upper rubber mount cap (1).
1
6. Remove lower rubber mount cap (2).
2
7. With driveshaft housing tilted fully down, remove the nut
3
from each lower rubber mount bolt. Do not remove the
bolts.
Driveshaft housing is free to fall if lower rubber
mount bolts are removed.
8. Hold driveshaft housing securely. Pull out lower rubber
4
mount bolts (3) and remove driveshaft housing. Place
housing on bench for disassembly.
5-10
CAUTION
T1336 T1266
T1267
T1268
T1269
3-/ 4-Cylinder