Disassembly Of Compressor Housing - TOHATSU MD 70-90C2 Service Manual

Fuel System (TLDI)
2. Fix crank shaft at its lower end by using a vice, loosen
driven pulley securing nut, and then remove driven pulley.
Be careful not to damage the crank pin 1
area when fixing crank shaft using a vice.

5) Disassembly of Compressor Housing

Remove oil seal 1 and bearing 2.
1.
Heat compressor housing to 60 to 70 degrees
Centigrade (140 to 158 degrees Fahrenheit) by
using hot water before removing bearing 2.
Do not reuse removed bearing.
Heating of compressor housing can also be made
by using a heat gun or heat lamp.
4-34
CAUTION
CAUTION
1 Crank Pin
1
2
2
1 2
Do not reuse
1
TLDI 75/90C2 2010