Installation
1. Attach retainer (2) to shaft groove (G) with raised surface
22
of retainer facing bearing.
2. Coat new needle bearing with gear oil. Slide bearing onto shaft
so bearing stamped surface faces retainer (2).
Stamped surface of needle bearing must face
retainer or bearing could be damaged during
installation.
3. Slide guide B (4) onto shaft and insert shaft in propeller shaft
housing.
4. Slide stopper (8) and plate (5) onto shaft and secure with washer
(6) and nut (7).
5. Tighten nut (7) until stopper (8) contacts plate (5).
6. Remove tools and verify needle bearing is fully seated in housing.
Propeller Shaft Housing Needle Bearing -
Models 60C / 70C / 80 / 90 / 115 / 120 / 140
23 24
Obtain needle roller bearing puller kit. Reference the
following specification table for propeller shaft
housing needle bearing Removal and Installation
special tool requirements :
Tool
Shaft, Needle Bearing Puller
Retainer, Needle Bearing Puller
Guide B, Needle Bearing Puller
Plate, Needle Bearing Puller
Washer, 13-21-2.5
Nut, 12P1.5
Stopper, Needle Bearing Puller
3-/ 4-Cylinder
CAUTION
NOTE
Part Number
3B7-72702-0
1
3B7-72709-0
2
4
3B7-72710-0
5
3B7-72701-0
6
346-72707-0
7
3B7-72735-0
9
353-72704-0
GEARCASE
Model
60C / 70C / 80 / 90 / 115 / 120 / 140
60C / 70C / 80 / 90 / 115 / 120 / 140
60C / 70C / 80 / 90 / 115 / 120 / 140
60C / 70C / 80 / 90 / 115 / 120 / 140
60C / 70C / 80 / 90 / 115 / 120 / 140
60C / 70C / 80 / 90 / 115 / 120 / 140
60C / 70C / 80 / 90 / 115 / 120 / 140
T1443
6-39