TOHATSU 40 Service Manual page 222

DO NOT disconnect the CD Unit output
25 26
connector [terminals (4) and (5)]. Damage to the
CD Unit may result.
Repeat for each CD Unit output connector.
9. Attach lanyard to emergency stop switch.
10. Crank engine.
11. At cranking RPM, the tester should show the following result for
each CD Unit output:
• 130 DVA Minimum
12. If the test results for any CD Unit output is not within acceptable
range, replace the CD Unit. See Ignition System Repair Procedures-
CD Unit.
13. Reconnect all wires disconnected during test.
14. Return to flow chart.
3-/ 4-Cylinder
NOTE
ELECTRICAL SYSTEM
T1484
7-43