1. Mount the stern brackets on engine stand.
2. Fully assemble and install the manual tilt or gas assist tilt
components as illustrated in the Disassembly procedure or install
the power trim/tilt unit at this time as described in Section 8.
3. Place swivel bracket between stern brackets. Install
15
upper cylinder pin (1) if equipped, and bracket bolt (2).
Torque bracket bolt nut to specification.
16
Upper cylinder pin must be locked in place by washer
(3) and bolt (4) or new snap ring as applicable.
4. Connect bracket ground leads as required.
17
5. Install steering shaft.
18
Note the installation of friction plate (5) on manual tilt
models.
6. Slide lower mount bracket (6) onto steering shaft and
19
install new snap ring (7). DO NOT use old snap ring.
7. Fill all grease fittings. See Lubrication Chart in Section 2.
Installation
Installation is done in the reverse order of Removal.
3-/ 4-Cylinder
T1309
NOTE
NOTE
MIDSECTION
T1310
T1311
T1312
T1313
5-23